Listen Technologies LT-700-150 User Manual download pdf (Page 10)

LT-700 Inside Access Door

Mic Sensitivity Switch - it arrives set at MED, which will work for

most microphones. If your mic level is too low, change the switch

to HI; if the level is too high, switch to LO. (see page 7 for more

information)

Battery Select Switch - place in NiMH position ONLY if you are

using Nickel Metal Hydride batteries, otherwise, leave it in the

Alkaline position.

SQ Switch: shipped in the ON position, use a screwdriver or pen

to slide to the OFF position if needed. You should turn SQ off if

you are using any non Listen receiver or older Listen receiver that

does not have the SQ feature. (see page 14 for more information)

Mic Sensitivity

Switch

SQ Switch

Battery Select

Switch

LT-700 Top of Unit

A Note on Charging NiMH Batteries

If you are using NiMH batteries in any Listen product, you should

allow adequate time for the charger (charging case or LA-208) to

complete a full charge cycle on the batteries. This takes about 13

hours.

3.5mm Input Jack

A microphone or line level cable connects here.

LED indicators:

Steady Red: Normal operation

Slow Flashing: Battery is low

Slow Flashing while charging: Unit is charging

Fast Flashing: Mute

MUTE / TALK switch - this mutes the mic only and

not the line input when in the mute position.

LT-700 Quick Reference

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

No comments

Listen Technologies LT-700-150 User Manual Page 10